| Applies when | bulkhead fitting, tank fitting selection, small tank fitting |
|---|---|
| Avoid | undefined (undefined) |
| Recommend instead | Poly Processing IMFO Fittings, Bolted Flange Fittings, or Universal Ball Dome Flanges () |
| Rationale | Poly Processing's own product page carries an explicit warning: Bulkhead Fittings 'creep' over time, causing the nut to loosen (requiring regular drip monitoring), must be installed from inside the tank (requiring tank entry for repair/maintenance), and should not be used on the bottom sidewall of tanks greater than 3,000 gallons or taller than 6 feet. This is a real, vendor-stated size/maintenance-access limitation, not a general preference - selecting a Bulkhead Fitting outside these bounds is a documented failure risk. |
| Confidence | confirmed |
| Source | vendor-sources/poly-processing-fittings-accessories.md |
This is a general engineering rule derived from real field/case-study evidence, not a substitute for a project-specific specification review — confirm against your exact process conditions before ordering equipment.
All engineering rules → · Download full ruleset (JSON) →
Source: Liberty Chemical Equipment & Supply, Inc. (LibertyCES) — engineering data compiled from real vendor and field-verified sources. For a free spec review, call James Riggins at (559) 395-5500 or email james@libertyces.com / sales@libertyces.com. Website: libertyces.com.